Tii 605 Series Manuale Utente

TII P/N: 92221501 1385 Akron Street

TII P/N: 92221501 8.0 Adding or Changing Terminal Blocks 8.1 Using standard 7/16” terminal wrench remove existing ADX-5T block by backing out 2 nu

TII P/N: 92221501 8.4 Align block with mounting holes in terminal housing 8.5 Tighten mounting nuts one half turn past tight, do not over tig

TII P/N: 92221501 9.0 Replacement of Gel-filled ADX driver. 9.1 Using standard 7/16” terminal wrench, back driver nut off all the way out.

TII P/N: 92221501 9.4 Remove a new driver from its packaging and inspect it. Place the new driver over the glide plate, align with driver hole and

TII P/N: 92221501 10.0 Drop Wire Termination 10.1 Open terminal box door. 10.2 Prepare Wire / Cable Per Standard Practice. 10.3 Using

TII P/N: 92221501 10.6 Tool-less rocker accepts 22-24awg wire, lower ports To terminate 18.5-24 AWG wire (driver bolt actuated).

TII P/N: 92221501 11.0 Testing 11.1 Insert test clips into test ports and follow company procedure for testing. 12.0 Accessories • TII

TII P/N: 92221501 Aerial Cable Ground Bars 2.1 See TII Warranty. If this unit fails during the warranty period, the factory should be requested to aut

TII P/N: 92221501 4.0 Cable Preparation 4.1 Prepare cable and strand as shown in Figures 1 & 2. Note: Suggested method in preparing the

TII P/N: 92221501 5.0 ADX-5T Terminal Block Installation 5.1 Select the proper mounting configuration in the terminal housing for the desired termina

TII P/N: 92221501 5.3 Mount the terminal block(s) in multiple of five as required. 5.4 The Model 605-50 is equipped for mounting u

TII P/N: 92221501 6.4 Mount terminal to strand. Terminate shield bond connectors to terminal closure ground bond straps; ensure bond clamps are

TII P/N: 92221501 6.6 Splice as per standard practice. 6.7 Cable should be tie wrapped to the ground bar at each end for strain relief

TII P/N: 92221501 1 2 3 4 5 6 7Circumference TemplateStart Point 7.0 Cable Entry Gromme

TII P/N: 92221501 7.3 Cut end caps to fit cable, install in each end of terminal, and ensure a snug fit around cable. A wrap of vinyl tape sho